United States / North American reference
Verified specifications
Values are manufacturer-published or faithfully converted from the cited manufacturer record. Manufacturer-published dual units are retained where available, and the basis column travels with every value.| Specification | Metric | Imperial | Standard / configuration |
|---|---|---|---|
| Net engine power | 78 kW | 104 hp | At 1,900 rpm |
| Operating-weight range | 9,600–10,198 kg | 21,165–22,484 lb | Published model-family range |
What the specifications mean
The weight range is suitable for early screening, not a permit application.
Net power at a stated engine speed can be compared only with a compatible rating basis.
Smaller transport mass may matter more than peak production on dispersed work.
Configurations and options to verify
- Blade, shoe width, cab and rear equipment determine where a machine falls in the range.
- Grade-control preparation and installed components require individual verification.
- A complete undercarriage measurement is more useful than a claimed percentage without data.
Used 650 P-Tier inspection priorities
- Obtain measured undercarriage percentages and note whether components were replaced as a matched system.
- Inspect blade linkage, C-frame or push arms, equalizer bar, pivot points and structural repairs.
- Test steering and hydrostatic response in both directions under load.
- Verify grade-control sensors, displays, wiring, correction services and transferable licenses separately.
Hours, condition and ownership cost
Hours are context, not a condition grade. Duty cycle, idle time, maintenance evidence, wear-system measurements, structural repairs and installed technology should be evaluated together.
Cost drivers to model
- Undercarriage cost is duty-cycle dependent; rock, slope, travel and turning practices matter.
- Blade edges, ripper components, final drives, cooling and emissions systems need separate reserves.
- Compare production and finish requirements before assigning fuel and utilization assumptions.
Attachments and compatibility
- Blade and ripper details are configuration—not generic model attributes.
- Confirm hydraulic, mounting and control requirements for winches, rakes or specialty guarding.
Transport planning
- Use the exact blade position, shoe width and installed rear equipment when measuring the load.
- Wide LGP configurations may change routing and permit planning even when horsepower is unchanged.
Manufacturer provenance
Sources and verification notes
Each exact value above points to one of these first-party records.John Deere
Open manufacturer source 650 P-Tier Small Dozer
United States · exact model technical page · verified August 2026 · confidence: manufacturer-verified